Description

This project aims to bring multimaterial capabilities to 3D printers using a single Direct Drive toolhead. While this project is mainly dedicated to be used on V printers, it can also be used (or adapted) on any 3D printer that runs Klipper, and potentially RRF. Here is the link of this project://github.com/EtteGit/EnragedRabbitProject

Package: 

 6/9 colors:

Btech gears(optional)                         7/10 sets

3*20 shafts(optional)                          7/10 sets

Needle bearings(optional)                 14/20 

LM8UU bearings                                               2 

M5 threaded rods 156/224mm (optional)        2  

8mm smooth rods 171/239mm(optional)        2  D-cut 5mm shaft 201/269mm(optional)           2  MR623ZZ bearing                                              1  MR85ZZ bearings                                           5/6